Echoes of Idols
Your bias deserves better than a binder.
A two-part, 3D-printable holder for your 55 × 85 mm photocard — your artwork, your colours, your caption. Design it in the browser, print it at home.
Prints in ~3 hours · no supports · clicks together, no glue
Drag to spin · click to take it apart
From your screen to your shelf
The holder is a measured, print-tested two-part shell. The builder is how you make it yours.
Design it in the browser
Drop in artwork, add a caption in one of eleven typefaces, pick your colours and deco. Everything is inlaid flush into the shell — it prints as one clean face.
Export a print-ready file
One click gives you a multi-colour 3MF with every filament already assigned. Bambu Studio, Orca and Cura open it as-is; both halves print face-down with no supports.
Slide it together
The two halves join on a sliding dovetail with a click — no glue. Your card top-loads like a sleeve, and a 4 mm hole means it can hang wherever you want it.
Printed, not promised
Every dimension in the builder comes off a real print bed — the joint tolerance was settled with calipers and test tiles, not guesswork.
card inside, hand for scale
mid-slide
artwork visible
Be first through the door
The builder opens with a crowdfunding launch — early-bird spots are limited and the list hears first. One email when it goes live; nothing else.